Installation Instructions

This is a step by step instructional to install window graphics.

Wet Installation - Recommended for large graphics

Clean the glass thoroughly – Remove all dirt, dust, and grease.
Dry the window completely with a lint-free towel.
Hold the graphic up to the window and position it where you want it.
Tape the top edge with masking tape to create a hinge.
Lightly spray the glass with a water + dish soap mixture.
Peel the backing off the graphic slowly from the top down.
Let the adhesive side fall onto the damp glass.
Use a squeegee or credit card to smooth the graphic from the center outward, pushing out bubbles.
Wipe away excess water with a towel.
Smooth out any remaining bubbles—small ones will usually disappear in 24–48 hours.
Remove the top hinge tape.

Clean the surface thoroughly – Make sure it’s free of dust, dirt, and oils. Using alcohol to clean is advised.
Dry the area completely with a clean microfiber towel.
Position the graphic where you want it and secure the top edge with a small piece of tape. Check spacing with tape measure.
Peel back a small portion of the backing from the top edge.
Stick down the exposed edge of the graphic and press firmly, starting from the inside out. Push the air away from the middle to avoid bubbles.
Slowly peel off the rest of the backing while pressing the graphic down as you go.
Smooth with your fingers or a credit card from the center out to remove air bubbles.
Press down all edges to ensure full contact.